Business

HomeBusinessPrinter SettingsTwirll Printer Setup

Twirll Printer Setup

Step 1 : Connect Printer to Router

To connect your printer and POS to a wired network, you need an Ethernet cable.

Ensure the printer is connected to the same router that provides internet access to your POS Terminal, so both are on the same network.

    1. Connect one end of the Ethernet cable to the port on your printer.


    1. Connect the other end of the cable into a numbered Ethernet port on your router.


Your printer should now be part of the network. To connect the printer to the Back Office, you’ll need to locate its IP address.

If you wish to connect the cash drawer, then plug the one end of cash drawer cable in printer and another in cash drawer.

Step 2 : Get IP address of connected printer 

Turn off the printer and turn it on back after 10–20 seconds.


If the above method did not work, try this steps to get a self-test page and find the IP address.

  1. Turn off the printer.
  2. Press and hold the feed button.
  3. While holding the feed button, turn on the printer.
  4. Once the printer start printing, release the feed button.

The self-test page should display the IP address.
If it doesn’t work, reset the printer

Note : If the IP address shows as 0.0.0.0 192.168.192.168, the printer couldn’t establish a network connection. Ensure the Ethernet cable is connected between your printer and router properly, no loose end. You can also try a different Ethernet port on the router and repeat the steps above.

Step 3: Update IP address at Twirll Admin Portal

Once you obtain the IP address, update the same IP address at the defined Printer at Admin portal

Twirll Login > Operations > Advance Operation Setup


 


 

Was this article helpful to you? Yes No